Soil Survey Geographic (SSURGO) database for Franklin County, New York

Citation:

Description:

Time_Period_of_Content:

Status:

Spatial_Domain:

Keywords:

Access_Constraints: None

Use_Constraints: The U.S. Department of Agriculture, Natural Resources Conservation Service, should be acknowledged as the data source in products derived from these data. This data set is not designed for use as a primary regulatory tool in permitting or citing decisions, but may be used as a reference source. This is public information and may be interpreted by organizations, agencies, units of government, or others based on needs; however, they are responsible for the appropriate application. Federal, State, or local regulatory bodies are not to reassign to the Natural Resources Conservation Service any authority for the decisions that they make. The Natural Resources Conservation Service will not perform any evaluations of these maps for purposes related solely to State or local regulatory programs. Photographic or digital enlargement of these maps to scales greater than at which they were originally mapped can cause misinterpretation of the data. If enlarged, maps do not show the small areas of contrasting soils that could have been shown at a larger scale. The depicted soil boundaries, interpretations, and analysis derived from them do not eliminate the need for onsite sampling, testing, and detailed study of specific sites for intensive uses. Thus, these data and their interpretations are intended for planning purposes only. Digital data files are periodically updated. Files are dated, and users are responsible for obtaining the latest version of the data.

Point_of_Contact:

Browse_Graphic:

Attribute_Accuracy:

Logical_Consistency_Report: Certain node/geometry and topology GT- polygon/chain relationships are collected or generated to satisfy topological requirements (the GT-polygon corresponds to the soil delineation). Some of these requirements include: chains must begin and end at nodes, chains must connect to each other at nodes, chains do not extend through nodes, left and right GT-polygons are defined for each chain element and are consistent throughout, and the chains representing the limits of the file are free of gaps. The tests of logical consistency are performed using vendor software. All internal polygons are tested for closure with vendor software and are checked on hard copy plots. All data are checked for common soil lines (i.e., adjacent polygons with the same label). Edge locations generally do not deviate from centerline to centerline by more than 0.01 inch. The survey of Franklin County, New York, Northern Part is joined to the certified New york surveys of Clinton County, Akwesasne Territory: St.Regis Mohawk Reservation, Franklin County, Southern Part and Essex County.

Completeness_Report: A map unit is a collection of areas defined and named in terms of their soil components or miscellaneous areas or both. Each map unit differs in some respect from all others in a survey area and each map unit has a symbol that uniquely identifies the map unit on a soil map. Each individual area, point, or line so identified on the map is a delineation. Soil Scientists identify small areas of soils or miscellaneous areas that have properties and behavior significantly different than the named soils in the surrounding map unit. These minor components may be indicated as special features. If they have a minimal effect on use and management, or could not be precisely located, they may not be indicated on the map. A map unit has specified kinds of soils or miscellaneous areas (map unit components), each with a designated range in proportionate extent. Map units include one or more kinds of soil or miscellaneous area. Miscellaneous areas are areas that have little or no recognizable soil. Specific National Cooperative Soil Survey standards and procedures were used in the classification of soils, design and name of map units, and location of special soil features. These standards are outlined in Agricultural Handbook 18, Soil Survey Manual, 1993, USDA, NRCS; Agricultural Handbook 436, Soil Taxonomy, 1995, USDA, NRCS; and all Amendments; Keys to Soil Taxonomy, (current issue) USDA, NRCS; National Soil Survey Handbook, title 430-VI,(current issue) USDA, NRCS. The actual composition and interpretive purity of the map unit delineations were based on data collected by scientists during the course of preparing the soil maps. Adherence to National Cooperative Soil Survey standards and procedures is based on peer review, quality control, and quality assurance. Quality control is outlined in the memorandum of understanding for the soil survey area and in documents that reside with the Natural Resources Conservation Service state soil scientist. Four kinds of map units are used in soil surveys: consociations, complexes, associations, and undifferentiated groups. Consociations - Consociations are named for the dominant soil. In a consociation, delineated areas use a single name from the dominant component in the map unit. Dissimilar components are minor in extent. The soil component in a consociation may be identified at any taxonomic level. Soil series is the lowest taxonomic level. A consociation that is named as a miscellaneous area is dominantly that kind of area and minor components do not significantly affect the use of the map unit. The total amount of dissimilar inclusions of other components in a map unit generally does not exceed about 15 percent if limiting and 25 percent if nonlimiting. A single component of a dissimilar limiting inclusion generally does not exceed 10 percent if very contrasting. Complexes and associations - Complexes and associations consist of two or more dissimilar components that occur in a regularly repeating pattern. The total amount of other dissimilar components is minor extent. The following arbitrary rule determines whether complex or association is used in the name. The major components of an association can be separated at the scale of mapping. In either case, because the major components are sufficiently different in morphology or behavior, the map unit cannot be called a consociation. In each delineation of a complex or an association, each major component is normally present though their proportions may vary appreciably from one delineation to another. The total amount of inclusions in a map unit that are dissimilar to any of the major components does not exceed 15 percent if limiting and 25 percent if nonlimiting. A single kind of dissimilar limiting inclusion usually does not exceed 10 percent. Undifferentiated groups - Undifferentiated groups consist of two or more components that are not consistently associated geographically and, therefore, do not always occur together in the same map delineation. These components are included in the same named map unit because their use and management are the same or very similar for common uses. Generally they are grouped together because some common feature, such as steepness, stoniness, or flooding, determines their use and management. If two or more additional map units would serve no useful purpose, they may be included in the same unit. Each delineation has at least one of the major components, and some may have all of them. The same principles regarding the proportion of minor components that apply to consociations also apply to undifferentiated groups. The same principles regarding proportion of inclusion apply to undifferentiated groups as to consociations. Minimum documentation consists of three complete soil profile descriptions that are collected for each soil added to the legend, one additional per 3,000 acres mapped; three 10 observation transects for each map unit, one additional 10 point transect per 3,000 acres. A defined standard or level of confidence in the interpretive purity of the map unit delineations is attained by adjusting the kind and intensity of field investigations. Field investigations and data collection are carried out in sufficient detail to name map units and to identify accurately and consistently areas of about 4 acres.

Positional_Accuracy:

Lineage:

Direct_Spatial_Reference_Method: Vector

Point_and_Vector_Object_Information:

Horizontal_Coordinate_System_Definition:

Entity_Type:

Overview_Description:

Distributor:

Distribution_Liability: Cornell University provides these geographic data "as is". Cornell University makes no guarantee or warranty concerning the accuracy of information contained in the geographic data. Cornell University further makes no warranty either expressed or implied, regarding the condition of the product or its fitness for any particular purpose. The burden for determining fitness for use lies entirely with the user. Although these files have been processed successfully on computers at Cornell University, no warranty is made by Cornell University regarding the use of these data on any other system, nor does the fact of distribution constitute or imply any such warranty.

Standard_Order_Process:

Distributor:

Resource_Description: Franklin County, New York, SSURGO

Distribution_Liability: Although these data have been processed successfully on a computer system at the U.S. Department of Agriculture, no warranty expressed or implied is made by the Agency regarding the utility of the data on any other system, nor shall the act of distribution constitute any such warranty. The U.S. Department of Agriculture will warrant the delivery of this product in computer readable format, and will offer appropriate adjustment of credit when the product is determined unreadable by correctly adjusted computer input peripherals, or when the physical medium is delivered in damaged condition. Request for adjustment of credit must be made within 90 days from the date of this shipment from the ordering site. The U.S. Department of Agriculture, nor any of its agencies are liable for misuse of the data, for damage, for transmission of viruses, or for computer contamination through the distribution of these data sets. The U.S. Department of Agriculture (USDA) prohibits discrimination in all its programs and activities on the basis of race, color, national origin, sex, religion, age, disability, political beliefs, sexual orientation, or marital or family status. (Not all prohibited bases apply to all programs.)

Standard_Order_Process:

Metadata_Date: 20231222

Metadata_Contact:

Metadata_Standard_Name: FGDC Content Standard for Digital Geospatial Metadata

Metadata_Standard_Version: FGDC-STD-001-1998

Metadata_Time_Convention: local time